New England Ropes - Endura Braid Euro Style - Solid Color 3/8 in. - 10 mm
Quantity in Basket:
New England Line Selection Guide
Endura Braid Euro Style was developed in conjunction with leading riggers worldwide and tested in the harshest of
conditions, Endura Braid Euro Style surpassed the standards of performance time and again. Endura Braid is New England's most popular Dyneema double
braid rope. Use for all running rigging requiring a durable, low stretch, lightweight line.
• Topping lifts.
• Reef Lines.
• Low-stretch control lines.
Part Number: NEEND06
|| 8 mm
|| 10 mm
|| 11 mm
Sunlight/UV: Very little degradation from sunlight. Can be used outside over long term if inspected regularly.
Chemicals: Polyester has good resistance to most chemicals except 95% sulfuric acid and strong alkalines at boil. HMPE has good resistance to most minerals, organics, acids, and weak alkalines. HMPE also has excellent resistance to bleaches and other oxidizing agents and to most solvents.
Heat: Polyester melts at 480°F with progressive strength loss above 300°F. HMPE melts at 300°F with progressive strength loss above 150°F. Technora melts at 1200' F.
Dielectrics: Good resistance to the passage of electrical current. However, dirt, surface contaminants, water entrapment, and the like can significantly affect dielectric properties. Extreme caution should be exercised any time a rope is in the proximity of live circuits.
Sheaves: Recommended sheave diameter to rope diameter is 8:1.
Working Loads: No blanket safe working load (SWL) recommendations can be made for any line because SWL's must be calculated based on application, conditions of use, and potential danger to personnel among other considerations. It is recommended that the end user establish working loads and safety factors based on best practices established by the end user's industry; by professional judgment and personal experience; and after thorough assessment of all risks. The SWL is a guideline for the use of a rope in good condition for non-critical applications and should be reduced where life, limb, or valuable property is involved, or in cases of exceptional service such as shock loading, sustained loading, severe vibration, etc. The Cordage Institute specifies that the SWL of a rope shall be determined by dividing the Minimum Tensile Strength of the rope by a safety factor. The safety factor ranges from 5 to 12 for non-critical uses and is typically set at 15 for life lines.